E10 is a Bertazzoni tumble dryer diagnostic usually grouped with a possible heating-related problem. This page keeps DIY limits clear; recurring faults belong with an independent technician at Bertazzoni Appliance Repair.
Reviewed by Marco Bellini · Last reviewed August 12, 2026
Written by
Marco Bellini Appliance Repair Content SpecialistPublished August 10, 2026Technically reviewed August 12, 2026
Content status:
Needs Technical Review — this entry is awaiting technical verification and should be confirmed before it is relied upon.
Error codeE10
ApplianceTumble Dryer
Affected model seriesBertazzoni Tumble Dryer series with on-display diagnostics (model-dependent)
Quick answer
E10 on a Bertazzoni tumble dryer: plain-language overview tied to a heating issue — not factory service literature.
Model compatibility: Bertazzoni reuses codes across series and model years, so E10 may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
Plain language
What this code means
E10 on a Bertazzoni tumble dryer is often a clue pointing toward a possible heating-related problem. Treat this as plain-language guidance and verify against the use-and-care or tech sheet for your exact unit. Treat this as independent homeowner guidance from Bertazzoni Appliance Repair, not a substitute for model-specific service literature.
Signs
Symptoms you may notice
The tumble dryer shows E10 and results are cold or under-heated
The cycle runs longer than usual before E10 appears
Heating seems weak or absent when E10 is shown
Why it happens
Possible causes
A heating element or its relay
A control or sensor affecting heating
Limescale or wear reducing heat on some models
Before you call
Safe checks you can make
These are simple, non-hazardous checks only. If anything is unclear, stop and contact a technician.
Confirm the appliance has power at the outlet
Allow the appliance to cool fully before any check
Perform a manufacturer-approved restart
Record the full Bertazzoni model and serial numbers before contacting a technician
Important safety warning. Do not open internal panels, access high-voltage wiring, or bypass any safety device. If you see smoke, sparks, a burning smell, or water near electrical parts, switch the appliance off at the outlet if it is safe to do so and call a professional.
Please avoid
What not to attempt
Do not open internal panels or access high-voltage components
Do not bypass door locks, safety switches or interlocks
Do not keep running the appliance if there is water near electrical parts, a burning smell or sparks
Get help
When to call a technician
Recurring E10 is a signal to stop homeowner experiments. Bertazzoni Appliance Repair can test the fault path safely and give a written estimate before parts.
Seeing this code on your Bertazzoni appliance?
Book a specialist visit for a clear estimate and approval before any repair. Independent service — not an official Bertazzoni service center.
You can safely try the basic checks above and one manufacturer-approved restart. If E10 returns, book Bertazzoni Appliance Repair rather than repeating resets.
The same characters can map to different subsystems on different Bertazzoni controls. Always verify E10 against your unit’s documentation.
No. Bertazzoni Appliance Repair publishes independent repair guidance for homeowners. Use your Bertazzoni model manual for manufacturer wording, then book an independent technician if the fault continues.
References
Sources & references
Bertazzoni use-and-care guide for your model — fault indicators
